Grace Digital GDI-IRDT200 Tuner - Manual (Page 13)

13
Step 3 - Connect to the wireless network
When the ESSID for the router you want to connect is displayed on the screen, press OK.
IF your network is not configured to require an encryption code, the screen should display:
Connecting to
Network
then:
Network OK
IF the screen displays either WEP or WPA, a password is required:
Enter WEP key
OR
Enter WPA key
Then the network is using one of the encryption systems: Wired Equivalent Privacy (WEP) or
WiFi Protected Access (WPA or WPA2). You therefore need to enter the correct WEP or WPA
password on your TUNER to communicate with your network.
Only the person who set up the network in the first place knows this password; if that person is
not you then you need to find out the password. You can confirm the password set by checking
with the Customer Service of your internet provider or the manufacturer of your wireless router.
HINT:
The password / encryption code
(WEP or WPA code ) would have
been set up by the person who set
up and configured your network.