Grace Digital GDI-IRDT200 Tuner - Manual (Page 35)

35
should accept to upgrade however you can press the Tuner’s ‘Back’ button to cancel the Tuner
from beginning the firmware upgrade. A Firmware upgrade may take several minutes.
IMPORTANT do NOT interrupt the upgrade once started. Do NOT switch off the power to the
Tuner until the operation is complete or permanently damage may result.
<Language>
Allows you to change the display language.
<Reset to Factory Defaults>
Puts all the settings back to their defaults as they were when the unit left the factory. If you
perform a factory reset on your tuner you will lose all your presets and your wireless network
connection.
Please note that your Tuner’s serial number will still be registered with your Grace Digital
internet tuner account (assuming you already registered the tuner). Any premium station
passwords, my stuff stations and podcast that were saved on our web site will be saved all re-
associate with your tuner after you power back on, log onto your network and download a new
stations list.
<Get Registration Key>
This will display a key that can be used to register the tuner on the Grace Digital Customer
portal: http://myradio.gracedigital.com
<Clock Setup>
Use this option to set the time, to set an alarm and to view the current alarm setting, see
“Setting the alarm”.
<Backlight Settings>
Selecting this option will alter the Internet tuner’s backlight brightness.
1. After selecting the ‘Backlight’ menu item, the tuner will display its list of three menu modes:
‘Inactive’, ‘Active’ and ‘Standby’. These three states are explained below:
• The tuner gets into its ‘inactive’ state when there is no button pressed for 30 seconds.