Clear-Com RS-603 (No longer available) - Manual (Page 12)

V - P A C K I N S T R U C T I O N M A N U A L 2 - 2
To create a custom setup for your beltpack:
1. From the Virtual Beltpack dialog box, do one of the following:
•Click Go Online to select and activate beltpack operating features in real
time.
•Click Setup to select beltpack operating features offline, so that you can
download the features to the beltpack later.
The Beltpack Setup dialog box appears.
2. From the Beltpack Setup dialog box, select a beltpack model, by doing one of
the following:
•If you are online, with a beltpack connected to the computer, V-Pack displays
the correct model, so that no action is required on your part. On the
Beltpack Setup screen, all incorrect model names are dimmed, so that only
the connected beltpack model is undimmed.
•If you are offline, you must select one of the beltpack models presented on
the Beltpack Setup screen.
3. Select a mode.
4. Select operating features for the selected mode.
You select features from three categories: operation, headset, and advanced.
Subsequent chapters in this manual describe each category in detail.
5. Save the operating features you select to a computer file, if desired.
FOR MORE INFORMATION
For specific information about V-Pack, refer to the appropriate chapter in this
manual.
• Programming beltpack options either online or offline to the computer. See
Chapter 3.
• Selecting a beltpack model. See Chapter 3.
• Selecting a mode. See Chapter 3.
• Selecting operating features for your beltpack. See Chapters 4, 5, and 6.
• Saving operating features to a computer file or “cloning” operating features.
See Chapter 7.
When you are online to
V-Pack, the changes you
make onscreen to a
beltpack’s operating
features take effect
immediately at the
connected beltpack. .