Clear-Com RS-603 (No longer available) - Manual (Page 8)

V - P A C K I N S T R U C T I O N M A N U A L 1 - 2
• Send and receive 24 kHz RMK signals.
• Contour the audio for maximum intelligibility in noisy environments.
• Reduce background noise with full-function Noise Gate.
• Select the earphone level for an auxiliary headset.
• Choose how a call signal occurs—as a steady, flashing, or dimmed light; as an
AC or DC signal; and/or as an audible tone in the headset. Or you can select
not to indicate call signals at all.
• Activate one or both talks.
• Temporarily interrupt a latched talk with Clear-Com’s exclusive
“bounce-back” feature.
• Listen on both channels simultaneously, or only on one channel, regardless of
which channel you are talking on.
• Operate on only one of the two channels.
• Reverse the position of the channel controls.
V-Pack gives you unprecedented versatility in programming a beltpack for any
operating environment.
ABOUT THIS MANUAL
This manual presents information about V-Pack so that new users can
understand and start operating the program as quickly as possible.
The manual complements the online help system. Both the manual and the help
files assume that you are familiar with the Windows operating system. If you are
new to Windows, you may find the Windows online help system useful.
MINIMUM SYSTEM REQUIREMENTS
V-Pack requires the following minimum system requirements:
• Microsoft Windows 98, ME, NT4, 2000, or XP.
• Personal computer with Pentium 2 or higher processor.
• 20 megabytes (MB) of free hard disk space.
• 64 MB RAM.
• Computer RS-232 serial port for connecting the beltpack programming cable
to the computer (if you only have USB ports, adaptors are available.)
• VPC-1 cable for connecting the beltpack to the computer. This cable is
available from your Clear-Com dealer or distributor as well as directly from
the factory. If you wish to wire your own cable, Table 1 gives the pin
assignments.
PIN FUNCTION
2 tip
When the VPC-1 cable is
connected, and V-Pack
started, you can select
beltpack features in V-Pack
and upload them to the
beltpack.
When you start V-Pack, the
connected beltpack’s
settings automatically
download to V-Pack and
display on the computer
screen.