Clear-Com RS-603 (No longer available) - Manual (Page 53)

V - P A C K I N S T R U C T I O N M A N U A L
7 - 3
NOTE: When you “clone” a beltpack’s settings, you automatically clone all four
modes. You can save settings or restore defaults to selected modes within a setup,
however.
Figure 2: Cloning a Beltpack Setup
ASSIGNING I.D. NUMBERS TO BELTPACKS
If you have several beltpacks that you regularly reprogram, assigning
identification numbers to individual beltpacks or groups of beltpacks allows you
to keep track of them more easily.
You can assign a three-digit alphanumeric code to each beltpack from V-Pack
that you can then read from V-Pack. You cannot read the code from the beltpack
itself.
To assign an identification number to a beltpack:
1. Connect the beltpack to the computer with the VPC-1 cable.
2. Start V-Pack in Windows.
3. From the Virtual Beltpack dialog box, click Go Online.
Click ON to turn on Beltpack Cloning.
Connect a beltpack to the computer.
(Disconnect the first beltpack, if you created the setup online.)
Click COPY. The beltpack setup uploads to the beltpack.
3
1
2
4
5
Create a beltpack setup in V-Pack, either online or offline.
Repeat for as many beltpacks as needed.