Hach-Lange SI794 D tr User Manual - Manual (Page 31)

Menu Code Choices
ALr Alarm settings
AL. Select Sensocheck ON / OFF
Enter alarm delay xxxx sec
LED in HOLD mode ON / OFF
rLAY Relay 1/2: Limit values, controller
rL. Select limit function / controller LiMIT / CtROL
Select contact function Lo / Hi L1.
Select contact response N/O / N/C
Enter setpoint xxxx
Enter hysteresis xxxx
Enter delay xxxx SEC
Select contact function xxxx sec L2.
Enter controller setpoint xxxx Ct.
Enter neutral zone xxxx
(P) Controller gain K
P
xxxx %
(I) Reset time T
R
xxxx SEC
(D) Rate time T
D
xxxx SEC
Pulse length / Pulse frequency PLC / PFC
PLC: Pulse length xxxx SEC
PFC: Pulse frequency xxxx /min
Select HOLD response Y Last / Y Off
Cln. Cleaning contact
Cn.
Select contact response N/O / N/C
Enter setpoint xxxx
Enter hysteresis xxxx
Enter delay xxxx SEC
Select cleaning contact or signaling of
parameter set 2
rinse / Pset2 rinse
rinse Cleaning interval xxx.x h 000.0 h
Cleaning duration xxxx SEC 0060 SEC
Select contact response N/O / N/C N/O
31