Hach-Lange ORBISPHERE K1100_M1100 Operator Manual - Manual (Page 27)

25
Installation
3.3.4 Connections (bottom of instrument)
A square key is provided to open the instrument front panel locks. The two locks are located on
the right side of the instrument on the top and bottom panels (bottom panel indicated with the
number 9 in
Figure 7 below).
The front panel can be easily pivoted to the left as shown below. To retain the instrument
waterproof tightness, make sure the seal is clean and in good condition before closing the front
panel.
Note: The type of power cable connection will vary depending on the instrument specification.
Figure 7 Wall and pipe mount connection
panel
1 - Power cable 6 - External pressure sensor connection
2 - USB-B client 4 pin connector 7 - Input/Output 2 cable gland
3 - Ethernet cable gland 8 - Input/Output 1 cable gland
4 - Sensor connection 9 - Keylock
5 - USB-A host connector for mass storage device