INSTEON Hub - 2242-222 (US), 2242-422 (EU), 2242-442 (UK), 2242-522 (AUS/NZ) Manual - Manual (Page 17)

Page 17 of 26 Rev: 9/27/2013 4:17 PM
5) Adjust the scene member response by tapping the green button or use the current state displayed.
6) If you wish to also activate the scene from another INSTEON device (motion sensor, keypad, switch, etc.) tap
the blue Responder button. If the button is grayed out (either Responder or Controller), this means the device
can only be one or the other.
7) When finished tap Save Scene
The app will begin linking to each scene member
If a sensor was selected, follow the onscreen instructions for adding them to the scene as a controller
8) When finished, the app will ask if you want to turn the scene members off – this may be convenient if you have
created an All Lights scene and you simply want to turn off all members.
Controller
(grayed out):
A controller-only
device (e.g.,
motion sensor) Responder
(grayed out):
A responder-only
device (e.g., older
plug-in module)
Responder:
member will only
be activated by
the scene Both:
member will activate
and be activated by
the scene Controller:
member will
only activate
the scene
Example showing a dimmers’
on level and ramp rate