INSTEON Hub - 2242-222 (US), 2242-422 (EU), 2242-442 (UK), 2242-522 (AUS/NZ) Manual - Manual (Page 24)

Page 24 of 26 Rev: 9/27/2013 4:17 PM
X10 minimum receive level 20mV into 5 Ohms
X10 messages repeated No
Mechanical
Mounting
Wall Mount
Wires
N/A
Screw clamp connections N/A
Case color White
Set button 1
Plastic UV stabilized polycarbonate
Beeper Yes
LED 1, RGB
Dimensions 7” H x 4” W x 1.5” D (17.8cm x 10.2cm x 3.8cm)
Weight 5oz (142g)
Operating environment Indoors
Operating temperature range 0
o
to 40
o
C / 32
o
to 104
o
F
Operating humidity range 0-90% relative humidity
Storage temperature range -20
o
to 70
o
C / -4
o
to 158
o
F
Electrical
Voltage 100VAC to 240VAC
Frequency 50/60Hz auto detected at power-up
Retains all settings without power Yes, saved in non-volatile EEPROM
Standby power consumption < 0.75 watts
Safety approved CE, C-Tick, CTL/US
Certifications
EN 300 220-2, 301 489-3
AS/NZS 4268, CISPR 22
IEC 60669-2-1
FCC / IC
Certification and Warranty
DECLARATION OF CONFORMITY
Hereby, INSTEON declares that this device is in compliance with the essential requirements and other relevant provisions of the following Directives:
1) Low Voltage Equipment Directive 2006/95/EC
2) Electromagnetic Compatibility Directive 2004/108/EC
3) Hazardous Substance Directive 2005/95/EC
Technical data and copies of the original Declaration of Conformity are available and can be obtained from INSTEON; 16542 Millikan Ave, Irvine, CA, USA.
User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste Electric and Electronic Equipment (WEEE)
This document contains important information for users with regards to the proper disposal and recycling of INSTEON products. Consumers are required to comply
with this notice for all electronic products bearing the following symbol: