Anthem Audio AVM 30-HD - Manual (Page 34)

26
Procedure for Manual Test Sequence:
• Enter the Setup Menu. Go to ‘4. SPEAKER LVL CALIBRATION’ and press SELECT.
• Use the buttons to set TEST SEQUENCE to ‘Manual’.
• Press the buttons to go from speaker to speaker.
• As each speaker plays, use the buttons to adjust its loudness relative to other speakers.
• Press BACK to stop the test tone.
Procedure for Auto Test Sequence:
• Enter the Setup Menu. Go to ‘4. SPEAKER LVL CALIBRATION’ and press SELECT.
• Use the buttons to set TEST SEQUENCE to ‘Auto’.
• Press SELECT to start the automatic sequence.
• As each speaker plays, use the buttons to adjust its loudness relative to other speakers. Once
set, the sequence will automatically advance to the next speaker for adjustment. It will then
continue to cycle speaker by speaker to allow you to fine tune all levels.
• Press BACK to stop the test tone.
3. SETUP MENU
continued …