Anthem Audio AVM 30-HD - Manual (Page 72)

64
4. OPERATION
continued …
4.12 SLEEP TIMER (Remote Control Only)
If you would like to go sleep while listening to a program or music, the Sleep Timer will automatically
turn the AVM 50 power off after the selected amount of time. So when you find yourself falling
asleep at the TV, take the Remote Control and:
• Select the desired Path (MAIN, ZONE2, or ZONE3), then press SLEEP (the Sleep timer will operate
for that Path only).
• The first SLEEP keystroke always resets the timer to 30 minutes. Additional keystrokes then cycle
as follows: Second=60, third=90, fourth=Disabled.
• Once set, the time remaining appears as the number following ‘Zzz’ in the display.
4.13 ENABLE / DISABLE TIMERS (Remote Control Only)
To enable or disable all timers without entering the Setup, press and hold the SLEEP key until the display
shows ‘ALL TIMERS’, then use the
keys to enable/disable (see section 3.1).
4.14 STATUS DISPLAY
Press, Release, Press to cycle through display screens that show the following:
• Software version, day, and time.
• Video Input: Resolution and refresh rate of video source, and
copy-protection status – “CP” means copy-protected, “NP”
means not protected. (See section 2.1.)
• Audio Input: Bit rate / sample rate of digital source, or Analog.
• Input Format: Channels in the source.
• Audio Output: Bit rate / sample rate mode of the digital to analog converters (always 24/192).
• Output Format: Channels producing output.
• Mode: Surround mode (section 4.8).
• DD/DTS 5.1 Dynamics: Normal, Reduced, or Late Night (section 4.8.10).
• Tone Controls: Enabled, Bypassed, or N/A (section 4.7).
• Sleep Mode: Enabled or Disabled (section 4.12).
• All Timers: Enabled or Disabled (sections 3.1 and 4.13).
• Serial Number: If the number on the rear panel does not match this, contact Anthem immediately.
When in ZONE2 or ZONE3, information relating only to the selected Path is displayed.
SLEEP
TIMERS
STATUS
SELECT