Programming macros, Resetting the remote to factory defaults, Remote control customization – Anthem Audio AVM 30-HD User Manual
Page 75: Continued
![background image](/manuals/33321/75/background.png)
67
5. REMOTE CONTROL CUSTOMIZATION
continued …
5.5
PROGRAMMING MACROS
Macros are used to execute multiple functions with a single key press, such as powering the AVM 50, cable
box, and display On at the same time. Up to 32 commands total can be programmed.
Programming a Macro that works regardless of control mode setting:
1. Press and hold LEARN until the LED flashes twice.
2. Press 9, 9, 5.
3. Press the key you want to use to activate your macro (e.g. Power).
4. Enter the command sequence that you want the macro to execute.
5. To exit, press and hold LEARN until the LED flashes twice, or wait 10 seconds.
To clear the macro, repeat the steps above, but skip step 4.
Programming a Macro that works in only one control mode:
1. Press the control mode key.
2. Press and hold LEARN until the LED flashes twice.
3. Press 9, 7, 8.
4. Press the key you want to use to activate your macro (e.g. Power).
5. Enter the command sequence that you want the macro to execute.
6. To exit, press and hold LEARN until the LED flashes twice, or wait 10 seconds.
To clear the macro:
1. Press and hold LEARN until the LED flashes twice, then release.
2. Press 9, 7, 8.
3. Press the control mode key where you programmed the macro.
4. Press the key that was programmed to activate the macro.
5. To exit, press and hold LEARN until the LED flashes twice, or wait 10 seconds.
5.6
RESETTING THE REMOTE TO FACTORY DEFAULTS
Press and hold LEARN until the LED flashes twice, then press 9, 8, 0.
If your remote control seems to have stopped working, try resetting it before contacting technical
support. As well, make sure the IR sensor wasn’t turned off – see section 3.10.