intimus MultiMedia - Manual (Page 5)

5
MALFUNCTION
TECHNICAL DATA
ACCESSORIES
COMPENSATION OF THE CONTROL PCB:
In order to eliminate malfunctions in the electronic
control it is possible to carry out a manual com-
pensation of the control PCB. The procedure is
as follows:
1. Switch off the maschine at the pushbutton
switch (1) and open the door.
2. Press the „reverse“ pushbutton switch (2) and
keep it pressed.
3. Press the „forward“ pushbutton switch (1).
4. Release the „reverse“ pushbutton switch (2)
after approx. 3 sec.
6. Close the door. The cutting system runs for-
ward.
The compensation of the control PCB is com-
pleted.
MATERIAL JAM IN MACHINE:
If too much material is fed in, causing a jam, the
machine will respond as follows:
- Cutting mechanism halts, then runs one step in
reverse (material will be released) and stops.
The motor shuts down automatically. The pilot
lamp (5) (fig. 1) lights up.
Proceed as follows:
- Briefly operate the pushbutton switch for reverse
(2) (fig. 1). The pilot lamp (5) (fig. 1) goes off.
- Activate the forward pushbutton (1) (fig. 1).
The material is once again fed to the cutting
system.
- If required, switch the cutting system alternately
to forward and reverse until all of the material
has been run through the cutting system and
shredded.
MOTOR PROTECTION:
The motor shuts down automatically, should it
become overloaded. Turn the machine off with
the pushbutton switch (1) (fig. 1).
Allow the motor to cool down for 15 to 20 minutes
(depending upon room temperature) and then
continue shredding.
CHECKLIST IN CASE OF MALFUNCTIONS:
If the device does not function, check the follo-
wing:
- is the
plug connected to the mains?
Mains connection: 2-pole mains switch,
internal appliance plug,
separate power cord
- is the pushbutton switch (1) on?
- is the door closed?
- is one of the receptacles full?
The receptacle has to be emptied.
- is there a
material jam in the machine?
Follow the instructions under ”MATERIAL
JAM”
- has the motor been overloaded?
Wait until the motor has cooled, and then re-
start.
If none of the above applies, please contact
your dealer.
Type of shredding: Particle or strip-cut
(depending
upon material)
Cutting capacity: 1 disk or cassette
at a time
or 2 floppy disks
Supply voltage: 230V/50Hz
240V/50Hz
120V/60Hz
100V/50/60Hz
Pre-fusing: 10 amps (slow-blow)
Working width:
3_” floppy disk or ZIP disk: 105 mm
4 mm DAT cassette:
80 mm
CD or DVD: 125 mm
Noise generation: approx. 53 dB(A)
Power: 1.1 kW
Dimensions:
Width:
660 mm
Depth: 430 mm
Height: 880 mm
Weight: approx. 55 kg
Description Order-No.
Plastic bag, 345 x 310 x 750 x 0,17 mm 83177
Note: For orders of special accessories and spare parts, please contact your dealer.
GB
DISPOSING OF THE MACHINE:
Dispose of the machine in an
environmentally sound fashion at the end
of its useful service life. Do not dispose of
any of the parts included in the machine
or its packaging with household trash.
DISPOSING
MultiMedia