CNB HDS4848E - Manual (Page 37)

36
PTZ can be sync with Event using its preset function. If Event occurs, PTZ moves to the position
where event and positions are pre set. The above menu shows, Sensor 1 is set to sync to
cameras 1,2,3 and 4. If you click PTZ section, PTZ preset (position) can be set for cameras in the
event of Sensor activation.
PTZ event related preset can be synch only with Sensor/Motion/Video Loss events. If there are
multi events occur to a camera at same time, it takes events in order of Sensor > Motion > Video
Loss.
2-6-2. MENU > EVENT > Motion
In Motion, system provides Motion Detection function. Set Motion Detection using Sensitivity,
View and Area options.
•
Sensitivity: Select motion sensitivity from Very Low to Very High.
• Area: Define the area for motion detection.
Press Setup under Area to define motions detection areas. The blocks indicate the area where is
defined for motion detection
•
Select Block: Use arrow keys to move around a box. Select individual blocks to set motion
zones. Use number keys to select and unselect blocks (When using a mouse, use a left button).
•
Clear Block: Unselect all blocks inside a box
• Select All: Select blocks on entire screen.
• Clear All: Unselect blocks on entire screen.
• View: View the appearance of motion zones on screen when motions is detected.