Codelocks CL625 Double Cylinder Mortice Lock - Manual (Page 14)

14
A) The CL600 range is
available in Back to Back
versions where the code is
on
both sides of the door.
To install the Back to Back
versions:
Follow instructions as for
non back to back versions
substituting the backplate and
handle 2, with the coded plate
with the through fixing holes.
Please note that each side
may be coded with the same
or different codes.
B) The CL600 range is also
available to work with most
single point panic pads or
bars. In this format the front
code plate only is supplied
with suitable fixing to connect
to most single point panic
pads and latches. If in doubt
ask.
To install the PK versions:
Step 1. The position of the
CL600PK on the door is
determined by the position of
the panic device.
Step 2. Mark the position of
the spindle hole for the panic
device on both sides of the
door.
Step 3. Place the CL600PK
gasket against the door with
the 20mm (
3 /
4
”) hole centred
over the mark for spindle hole.
Using the gasket as a template
mark the 3 x 10mm (
3 /
8
”)
holes for the through fixing
bolts. Repeat on the other
side of the door.
Step 4. Drill the 1 x 20mm (
3 /
4
”)
hole and the 3 x 10mm ( 3 /
8
”)
drilling holes, from both sides
to avoid splintering out the
face of the door.
Step 5. Countersink the
bottom fixing hole as
necessary so that the fixing
bolt lies flush with the door
face, underneath the panic
device.
Step 6. Fit the lever handle to
the CL600 front plate and
tighten the grub screw in the
handle. Enter the code of the
CL600 front unit and check
that the lever will turn fully –
see page 6. operation check.
Step 7. Fit the CL600 front
unit with the 3 fixing bolts.
Insert the spindle with the flat
blade into the CL600 front
unit, ensuring that the blade is
at the correct angle for the
hand of door - see diagram
page 8.
Step 8. Install the panic
device and make sure that
the CL600 front unit will fully
retract the latch or bolt.
Back to Back and PK versions - Models CL600/610/615BB & CL600/605PK
BACK TO BACK AND PK VERSIONS