Codelocks CL625 Double Cylinder Mortice Lock User Manual
Page 5
5
STEP 2
Take the BLUE or RED tipped
spindle and fit to the code
side according to the hand of
your door (see diagram).
Fit remaining spindle to inside
- non code side.
STEP 3
Cut three of the socket head
bolts to the required length
for your door.
Approximate overall length
should be door thickness plus
25mm (1”), to allow about
10mm (
3
/
8
”) of threaded bolt
to enter the outside plate.
STEP 4
Remove plastic insert plug
from frontplate. Apply the
front and back plates, with
the neoprene seals in
position, against the door,
over the protruding ends of
the spindle.
STEP 5
Fix the two plates together
using the socket head bolts,
starting with the top fixings.
Ensure that the two plates
are truly vertical and then
tighten the bolts using the
‘T’ shaped Allen key. Do not
use excessive force.
STEP 6
Fit the lever handles to suit
the hand of the door. To
change the hand of a lever
handle, loosen the grub
screw with the small Allen
key, reverse the lever handle
and fully tighten the grub
screw.
STEP 7
Ensure that the latchbolt
retracts after the code is
entered and the lever handle
is depressed. Now check the
operation of the inside lever
handle. If there is any binding
of the handles or latch then
loosen the bolts slightly and
reposition the plates until the
correct position is found, and
then re-tighten the bolts.
IF YOUR LOCKCASE ONLY HAS
HOLES ON EITHER SIDE OF THE
FOLLOWER (FIGURE 1 ‘B’),
PROCEED AS FOLLOWS:
STEP 1
Hold the neoprene seal
against the door, perfectly
vertically, with the rectangular
hole centrally over the follower.
Mark the top holes and the
holes on either side of the
follower if not already drilled,
using adaptor plate as guide,
then repeat the procedure on
the other side of the door.
Mark an extra hole on the
inside of the door in line with
the bottom fixing hole.
Remove the lock.
Drill the 4 x 10mm (
3
/
8
”) holes
from both sides for greater
accuracy, and to avoid
splintering out of the door
face. Check that the existing
spindle hole is at least 18mm
(
3
/
4
”). Drill the extra 12mm (
1
/
2
”)
hole 5mm (
3
/
16
”) deep on the
inside of the door to accept the
fixing nut on the adaptor plate.
Replace the lock.
STEP 2
Take the BLUE or RED tipped
spindle and fit to the code
side according to the hand
of your door (see diagram).
MODEL CL600/605 INSTALLATION INSTRUCTIONS