Codelocks CL625 Double Cylinder Mortice Lock - Manual (Page 8)

MODEL CL610/615 INSTALLATION INSTRUCTIONS
STEP 7
Take the BLUE or RED
tipped spindle and fit to the
code side according to the
hand of your door (see
diagram).
Fit remaining spindle to inside
- non code side.
STEP 8
Fit the latch support post into
back of the code side front
plate according to the hand
of your door, A for a right
hand door, or B for a left
hand door (see diagram).
STEP 9
Cut three of the socket head
bolts to the required length
for your door. Approximate
overall length should be
door thickness plus 25mm (1”)
to allow about 10mm (
3 /
8
”)
of threaded bolt to enter the
outside plate.
STEP 10
Apply the front and back
plates, with the neoprene
seals in position, against the
door, over the protruding
ends of the spindle.
STEP 11
Fix the two plates together
using the socket head bolts,
starting with the top fixing.
Ensure that the two plates
are truly vertical and then
tighten the bolts using the
‘T’ shaped Allen key. Do not
use excessive force.
STEP 12
Check that the lever handles
are correctly fitted for the
hand of door. To change the
hand of a lever handle,
loosen the grub screw with
the small Allen key, reverse
the lever handle and fully
tighten the grub screw.
STEP 13
Before closing the door,
enter the code and ensure
that the latchbolt will retract
when the lever handle is
depressed. Now check the
operation of the inside lever
handle. If there is any binding
of the handles or latch then
loosen the bolts and
reposition the plates slightly
until the correct position is
found, and then re-tighten
the bolts.
8