Comprehensive CSW-VGA211 - Manual (Page 6)

4
5 Using the CSW-VGA211 Automatic VGA / Audio Switcher
This section describes:
Connecting the CSW-VGA211 (see section 5.1)
Selecting the default master source signal (see section 5.2)
Connecting the REMOTE connector (see section 5.3)
5.1 Connecting the CSW-VGA211 Automatic VGA / Audio Switcher
To connect your CSW-VGA211, connect the 2 VGA INPUTS, with VGA
INPUT IN 1 set as the active master source signal, as the example in Figure 3
illustrates:
1. Connect a VGA/Audio source (for example, a PC (Master Source)) to the
VGA IN 1 HD15F connector and to the AUDIO IN 1 mini plug connector.
Both underside DEFAULT SELECT switches should be set to IN 1 (the
factory preset default), as section 5.2 describes.
2. Connect a second VGA/Audio source (for example, another PC) to the
VGA IN 2 HD15F connector and to the AUDIO IN 2 mini plug connector.
3. Connect the VGA OUT HD15F connector and the AUDIO OUT mini plug
connector to the acceptor (for example, a video monitor with speakers).
4. Connect (optional) an additional monitor to the VGA IN 1 LOOP HD15F
connector and release the loop termination switch to select Hi-Z. Select 75
on the loop termination switch if the VGA IN 1 LOOP is not connected.
5. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.