Liquid Controls Mechanical Eliminators - Manual (Page 4)

4
safeTy ProCedUres
Before disassembly of any meter or accessory component:
ALL INTERNAL PRESSURES MUST BE RELIEVED AND ALL LIQUID DRAINED FROM
THE SYSTEM IN ACCORDANCE WITH ALL APPLICABLE PROCEDURES.
-Pressure must be 0 (zero) psi.
-Close all liquid and vapor lines between the meter and liquid source.
For Safety Rules Regarding LPG, refer to NFPA Pamphlet 58 and local authorities.
Failure to follow this warning could result in property damage, personal injury, or death from fire and/or explosion, or other
hazards that may be associated with this type of equipment.
! WarnInG
be Prepared
safely evacuate
Piping system
In The evenT of larGe fIres or fIres ThaT are sPreadInG
n Evacuate the building and notify your local fire department.
n Stop the leakage only if you can safely reach the equipment.
In The evenT of sMall, ConTaIned fIres
ThaT yoU Can safely ConTrol
n Stop the leakage if you can safely reach the equipment.
n Use the appropriate extinguisher: Class B fire extinguisher, water, fog, etc., depending
on the materials.
n
If in doubt, call your local fire department.
!
!
In the event of
a Gas fire
In The evenT of a larGe Gas leak
n Evacuate the area and notify the fire department.
In The evenT of a sMall, ConTaIned Gas leak
n Stop the leak and prevent accidental ignition.
n Prevent the entrance of gas into other portions of the buildings. Some gases, such as
LPG, seek lower levels, while other gases seek higher levels.
n
Evacuate all people from the danger zone.
n See that the gas is dispersed before resuming business and operating motors.
If in doubt, notify your local fire department.
!
!
In the event of
a Gas leak