Magnum Venus Plastech Pro Gun CPD_PRTM - 1:1 - Manual (Page 32)

1:1 Classic Pro Gun Manual
Rev. 05/2012 Page | 32
Gun Handle Rebuild:
Disassembly Classic Pro Gun Handle
Note: If you are using the Automatic Pro gun you can skip the following
procedures and attach the Mounting plate (58704-1, 58682-1 or 58757-1 for Super
Pro Actuators) to the bottom of the actuator.
Note: The fitting on the side of the gun handle differs depending on the gun
assembly you have, if ordering replacement parts, please make sure you
reference the correct parts drawing.
Remove Trigger Assembly
1. Remove trigger locking hairpin.
2. Remove the fillister-head screw (F-FS-540-08) on the side of the gun-head.
3. Pull the trigger retainer and spool assembly from the gun handle interior.
Disassemble the Trigger Retainer
Note: If you gun handle has the conversion upgrade (CPG-1007-CK) note the
proper part numbers when ordering replacement parts.
1. Remove the upper screw (02647-3) on the trigger.
2. Pull the trigger retainer (58648-1) off the spool assembly.
3. Remove the o-ring (O-D-010) from inside the trigger retainer.