Magnum Venus Plastech Pro Gun CPD_PRTM - 1:1 - Manual (Page 37)

1:1 Classic Pro Gun Manual
Rev. 05/2012 Page | 37
Assemble Pro Gun Modules
If this is an Automatic Pro Gun Assembly a Handle will not be used a Mounting Pad will
be installed in place of the handle.
Note: The hole in the actuating bushing of the actuator must be facing up so the
bushing hole can receive the actuating stem of the gun block. The actuating stem
on the gun block must be in the hole of the actuator bushing. If you are unsure,
remove the front end cap of the actuator and look.
1. Install and align the Actuator Seal onto the actuator body.
2.
Using the four mounting screws (5106-6-1) secure the gun block to the actuator.
3.
Use the two mounting screws (58626-1) to secure the handle assembly to the
actuator assembly (58604-1).
Or
4.
Use the two mounting screws secure the mounting pad to the bottom of the
actuator.
Mounting Chopper
Note: If your 1:1 Pro Gun™ is used for chopping, perform the two steps, A and B:
A. Install the hex cap screw securing the chopper to the top of the gun block. Be
sure to install the eccentric stud in the chopper mount.
B. Attach the air tube that connects the chopper to the gun handle.