Magnum Venus Plastech Pro Gun CPD_PRTM - 1:1 - Manual (Page 35)

1:1 Classic Pro Gun Manual
Rev. 05/2012 Page | 35
C. Insert the balls (03198) in the trigger retainer, using a scribe to position the
balls into the detents in the trigger retainer.
3. Insert the o-ring (O-D-010) into the internal groove of the trigger retainer.
Note: Use the top of the spool assembly in the trigger retainer to prevent the
o-ring from falling through the retainer
4. Remove the tip of the spool assembly from the trigger retainer and reinsert the
spool assembly in the correct end of the trigger retainer. Rotate the shaft ¼ turn
as you push it in.
Note: Grease the end of the spool assembly with MVP Pro Gun Oil (6706-3-1).
5. Apply a drop of removable thread lock to the Torx screws (02647-3) then screw
the spool assembly to the trigger using Torx screw (02647-3).
6. Thoroughly lubricate the spool assembly and trigger retainer with MVP Gun Oil
(6706-3-1).
Attach Trigger Assembly to Handle
1. Insert the trigger assembly into the gun handle and secure with the fillister head
screw (F-FS-540-08) on the side of the handle.
Note: Be sure the front of the trigger retainer assembly is flush with the gun
handle before installing screw.
2. Install Trigger Hairpin (02970) as safety lock.