Front of the talon gun – Magnum Venus Plastech TALON Gun Internal Mix User Manual
Page 21
Talon Internal Mix Gun Manual
Rev. 10/2013
Page | 21
Front of the Talon Gun:
1. Properly clean and flush Mix Chamber and Spray Tip.
2. Unscrew the Nozzle Cap - remove the Spray Tip and Turbulent Mix.
3. Remove the two Cap Screws and the Mix Chamber from the Gun Block
4. Remove the Catalyst Injector from the Gun Block or Distribution Ring. Carefully
disassemble and clean then reassemble
5. Remove the Mix Housing Seal and Distribution Ring from the Mix Chamber.
6. Replace Seals and any damaged parts as necessary and reassemble.
Chopper Gun Front:
Note: the TLN-IC-100X-XX and TLN-IW-100X-XX Talon gun assemblies use the FT-
XXX or N-XXXXC Air Less Spray Tips.
Gun Head
Mix Housing Seal
Catalyst Injector
Distribution Ring
Mix Chamber
Cap Screw (2 places)
Turbulent Mixer
Spray Tip
Nozzle Cap