MAX PJR265(CE) - Manual (Page 17)

17
5. How to set and remove the SDS
Plus bit to the Tool holder
• Before setting / removing the SDS Plus bit
to the tool, keep the fingers away from the
Trigger switch, and remove the Battery
pack from the tool.
HOW TO SET THE SDS PLUS BIT
(Fig. T) Insert the SDS Plus bit to the Tool holder
(Fig. T 2) until a click is heard. Make sure to
check the bit is securely fixed by pulling the bit.
When the bit is unable to be inserted at the bot-
tom(when a click is not heard), rotate the bit a lit-
tle bit and try again.
HOW TO REMOVE THE SDS PLUS BIT
(Fig. U) Hold and press the Tool holder down-
ward, then remove the bit.
(Fig. V) Prior to set the SDS Plus bit to the tool,
clean the holder's end of the bit, then apply
grease (Use Shell ® Alvania S2 grease. ) to the
dent of the bit, as shown in the figure V.
6. How to operate the Changeover
lever
• Do not operate the Changeover lever, when
the tool is in operation.
(Fig. W) Change the operating mode by the
Changeover lever, depending on the object to
drill.
To change the operating mode, pressing the
Lock button (Fig. W 5), then turn the Change-
over lever(Fig. W 4) to drilling or hammer-drilling
position. When turning to either position, make
sure to check a click is heard.
For use in Steel or Wood material, set the lever
to the
for drilling.
For use in concrete, brick or stone, set the lever
to the
for hammer-drilling.
7. Drilling in Metal or Wood
For use in Steel or Wood material, set the lever
to the
for drilling.
1 Hold the tool firmly with both hands.
2 Point the bit straight to the drilling object.
Do not apply excess pressure to the drill-
ing object. Applying excess pressure may
reduce working efficiency, as well as
shorten the lifetime of the tool and the bit.
3 During the drilling operation, when the
tool is overloaded, the tool may automat-
ically stops operation. When this occur,
release the Trigger switch and pull the bit
out from the drilling object, then stop op-
eration.
Failure to do so may cause damage to the
tool.
• (Fig. X) When the LED lamp (Fig. X 8) lights
with Red color, it shows the tool is over-
heated and automatically stopped due to
overload or continuous operation.
During the LED lamp lights with Red color, the
tool does not operate although the Trigger
switch is pulled.
Approximately one minute later, the LED lamp
goes off and the tool becomes operational
again. However, for the best performance of
the tool, continue operation after the tool is
cooled down sufficiently.
4 When removing the bit from the drilling
object by operating the tool counter-
clockwise, hold the tool with both hands,
pull the bit out with operating the tool.
5 To operate the tool at the best perform-
ance, when start drilling, point the bit
with pulling the Trigger switch slightly
(slow speed). As the drilled hole getting
deep, pull the Trigger switch more to in-
crease the speed.
• When drilling in Metal or Wood, use proper
bit . Especially when drilling in Steel, use
proper lubricants. However, when drilling in
Brass or Cast iron, do not use lubricants.
WARNING
WARNING
CAUTION
CAUTION
PJR265_CE.book 17 ページ ２０１０年１０月１３日 水曜日 午後４時５１分