MAX PJR265(CE) - Manual (Page 20)

20
6. MAINTENANCE
• Before inspecting the tool, make sure that
the Battery pack is not set in the tool.
Failure to do so may cause serious injury.
• Before inspecting the Battery charger
JC928, make sure that the Charger is dis-
connected from the power supply.
1 Regularly inspect the tool
In order to maintain the performance of the
tool, periodically clean up and inspect the
tool.
Examine the screws regularly to make sure
they are securely tightened.
Incomplete tightening may result in an acci-
dent or breakage. If a screw is loose, re-
tighten it completely.
2 Do not lubricate the equipment
Absolutely do not lubricate this equipment.
Applying lubrication will remove the grease
inside of the tool, and cause problem on the
tool.
3 Do not soak the tool to any liquid. Do not
put any liquid in the tool.
• (Fig. X) When the Status indicator LED
blinks with Green color, it shows that the
after-servicing by MAX authorized distribu-
tor is recommended.
When this happens after releasing the Trig-
ger switch, contact MAX authorized distrib-
utor for the afterservice.
7. STORAGE
Do not store the tool in a cold weather envi-ron-
ment. Keep the tool in a warm area.
When not in use, the tool should be stored in a
warm and dry place. Keep out of reach of chil-
dren. All quality tools will eventually require serv-
icing or replacement of parts because of wear
from normal use.
STORE THE TOOL
When you have finished drilling / hamer-drilling
work or when the tool will not be used for a while,
remove the battery pack from the tool. Tool, at-
tachments and accessories should be stored in a
well-ventilated dry place where the temperature
will not exceed 40°C (104°F).
The battery pack, with a pack cap installed on
the pack's terminal to prevent short circuits,
should be stored in a well-ventilated dry place
where the temperature will not exceed 30°C
(86°F).
WHEN STORING THE BATTERY PACK FOR A
LONGER TIME THAN 6 MONTHS WITHOUT
USE,
TO KEEP THE PERFORMANCE OF THE BAT-
TERY PACK, FOLLOW THESE INSTRUC-
TIONS ;
• Fully recharge before storage.
• Put a Pack cap on the Battery pack's ter-mi-
nal to prevent short circuits.
• Store the Battery pack in a well-ventilated
dry place where the temperature will not be
less than -20°C(-4°F) and will not exceed
30°C (86°F).
• Do not store the Battery pack in a place
where is under direct sunshine.
WARNING
CAUTION
CAUTION
PJR265_CE.book 20 ページ ２０１０年１０月１３日 水曜日 午後４時５１分