Trouble shooting/repairs, Warning – MAX RB397(USA) User Manual
Page 26
27
9. TROUBLE SHOOTING/REPAIRS
The troubleshooting and/or repairs shall be carried out only by the MAX CO., LTD. authorized distribu-
tors or by other specialists.
This tool alerts you to the following conditions by means of a warning sound and warning lamp. The
warning lamp is illuminated or blinks, and is interlocked with the warning sound. Take a countermeasure
according to the following table.
• If any of the following conditions occur, be sure to set the Main switch to OFF before carrying
out the countermeasures.
• When setting the Main switch to ON, do not touch the tying part of rotating part of the tool's tip.
If the problem is not solved by carrying out the following countermeasures, be sure to set the
Main switch to OFF and then contact the dealer where the equipment was purchased or MAX
CO., LTD. authorized distributors.
No. Normal Operation
Problem
Warning
Sound
Cause
What to Check
Solution
1.
Power ON
→ The
Tip Axis is initialized
and the wire-cutter
operates automati-
cally.
No operation
takes place.
No sound
emitted.
Dead battery (Com-
pletely empty)
Confirm the battery is
charged.
Perform normal charge.
Electrode plate has
been oxidized.
Taking out the battery,
see if electrode has been
browned.
Polish terminal part of
battery pack with dry
cloth, etc.
A long beep
(Piii...)
Curl guide is left
open.
Open/close curl guide
Fully close curl guide.
Continuous
short beeps
(Pi, pi, pi, ...)
Binding wire has
been entangled
around Twist sec-
tion.
Turn off power and take
out battery to confirm if
binding wire has been
entangled inside curl
guide.
Turning off power, re-
move binding wire inside
curl guide.
Two short
beeps repeat-
ed for 10 sec-
onds (Pipi,
Pipi, ...), then
power off au-
tomatically
Battery is empty.
Confirm the battery is
charged.
Perform normal charge.
The battery pack is
inserted when the
Main switch is ON.
Make sure to insert the
battery pack, only when
the Main switch is OFF.
Set the Main switch to
OFF, then ON.
2.
Power On
→ LED
lamp is lit.
→ No op-
eration over 30 min-
utes
→ LED lamp
goes off.
→ Al-
though pulling the
trigger, no opera-
tion takes place.
No operation
takes place, al-
though pulling
the trigger
A short beep
(Pi), (before
LED lamp
goes off)
Normal operation.
Set the Main switch to
OFF, then ON.
Set the Main switch to
OFF, then ON.
3.
Trigger ON
→ Wire
sent out.
No sending of
wire takes place.
A long beep
(Piii...)
Curl guide is left
open.
Open/close curl guide
Fully close curl guide.
Three short
beeps repeat-
ed
(Pipipi,
pipipi, ...)
Tie-Wire has been
run out.
Check if the Tie-Wire has
been run out or not.
Set the new Tie-Wire.
Wire caught inside
reel.
Check if wire inside reel
has been loosened and
caught.
Remove fray on reel.
Cutter section is
blocked with foreign
substance.
Confirm functioning of
Cutter section.
Either wipe Cutter sec-
tion with dry cloth or blow
it with air.
Five short
beeps
(Pipipipipi,
pipipipipi)
Motor has been
heated.
Warning sound does not
go continuously. It occurs
only when trigger is
pulled.
Halt Machine and cool it
down.
WARNING