MAX RB397(USA) - Manual (Page 5)

6
15. USE ONLY THE AUTHORIZED BATTERY
PACK
Use only MAX JPL914 battery pack. If the
tool is connected to a power supply other
than the authorized pack, such as a re-
chargeable battery, a dry cell, or a storage
battery for use in automobiles, the tool may
be damaged, break down, overheat, or even
catch on fire. Do not connect this tool to any
power supply except the MAX JPL914 bat-
tery pack.
16. TO ENSURE MAXIMUM PERFORMANCE,
FULLY CHARGE THE BATTERY BEFORE
USE
A new battery pack or one not used for ex-
tended periods may have self-discharged
and thus may need recharging to restore it to
a fully charged condition. Before operating
the tool, make sure to charge the Battery
pack with the designated MAX Battery charg-
er JC928.
17. BATTERY CHARGING PRECAUTION
1 Use only MAX Battery charger JC928
and Battery Pack JPL914
Failure to do so may cause the Battery to
overheat or catch fire leading to serious
injury.
2 Charge the Battery from AC 120V wall
sockets
Failure to do so may result in overheating,
or inadequate charging possibly causing
serious injury.
3 Never use a transformer
4 Never connect the Battery charger to
an engine generator direct-current
power supply
The charger will break down or be dam-
aged from burning.
5 Avoid charging the Battery pack in the
rain, in a damp place, or where water is
splashing
Charging a damp or wet Battery pack will
cause an electric shock or a short circuit
that may lead to damage from burning
and even the tool catching on fire.
JPL914
JC928
JC928
AC 120V