MAX RB397(USA) - Manual (Page 27)

28
3. Trigger ON → Wire
sent out.
Sending of wire
is stopped half-
way.
Four short
beeps repeat-
ed
(Pipipipi,
pipipipi, ...)
Tie-Wire is not set in
the tool.
Check if the Tie-Wire has
been set in the tool.
Set the Tie-Wire.
Binding wire not of
designated types
has been used.
Confirm reel side face. Use MAX Tie-Wire
TW897A.
Three short
beeps repeat-
ed
(Pipipi,
pipipi, ...)
Binding wire has
been entangled in-
side reel.
Confirm reel winding Remove fray on reel.
4. Binding wire draws
a circle.
Curl is disor-
dered and steps
out of curl guide.
No sound
emitted.
Wire, by hitting Rein-
forcing bars, was re-
pelled.
Check if wire hits Rein-
forcing bars at binding.
Pay attention so that
wire does not hit Rein-
forcing bars at binding.
5. Wire is subject to
cutting.
No wire cutting
takes place.
No sound
emitted.
Cutter section is
blocked with foreign
substance.
Confirm function of Cut-
ter section.
Either wipe Cutter sec-
tion with dry cloth or blow
it with air.
6. Wire twisting takes
place.
Wire gets entan-
gled.
No sound
emitted.
Wire, by hitting Rein-
forcing bars, was re-
pelted.
Check if wire hits Rein-
forcing bars at binding.
Pay attention so that
wire does not hit Rein-
forcing bars at binding.
(SEE PAGE 23)
A short beep
and a long
beep, repeat-
edly.
(Pipipipipipi...)
Binding wire has
been entangled
around Twist sec-
tion.
Turn off power and take
out battery to confirm if
binding wire has been
entangled inside curl
guide.
Turning off power, re-
move binding wire inside
curl guide.
Binding power is
weak.
No sound
emitted.
Reinforcing bars is
not of designated
size.
Confirm size of Reinforc-
ing bars to be bound.
(SEE PAGE 12)
Use appropriate diame-
ter scope.
Erroneous handling
such as improper ap-
plication of Machine.
Confirm how to apply Ma-
chine to Reinforcing bars.
Turning Torque dial in +
and inserting in vertical
direction, use as tilting at
45°. (SEE PAGE 22
AND 23)
Function of curl
guide switch
Check if curl guide is left
open at binding.
Do not operate Machine
until binding is complet-
ed.
Twisting-off
takes place.
No sound
emitted.
Reinforcing bars is
not of designated
size.
Confirm size of Reinforc-
ing bars at binding.
(SEE PAGE 12)
Use appropriate diame-
ter scope.
Erroneous handling
such as improper ap-
plication of Machine.
Confirm how to apply Ma-
chine to Reinforcing bars.
Turning Torque dial in –
(minus) and inserting in
vertical direction, use as
tilting at 45°. (SEE PAGE
22 AND 23)
Works properly Two short
beeps.
(Pipi)
Low power remains
in the Battery pack.
Confirm the battery is ful-
ly charged.
Perform normal charge
after the tying speed
slows down considera-
bly.
The tool is used at
low temperature.
Check the temperature at
the job site.
Leave the tool and the
battery pack at normal
temperature in the room
for some time, and then
continue the operation.
No. Normal Operation Problem
Warning
Sound
Cause What to Check Solution