MAX RB397(USA) - Manual (Page 3)

4
1. WEAR SAFETY GLASSES OR GOGGLES
The employer and the user must make sure
that proper eye protection is worn when the
tool is being used. Eye protection equipment
must conform to the requirements of the
American National Standards Institute, ANSI
Z87.1 (Council Directive 89/686/EEC of 21
DEC. 1989) and it must provide frontal and
side protection.
NOTE: Nonside-shielded spectacles and
face shields alone do not provide adequate
protection.
2. EAR PROTECTION MAY BE REQUIRED
IN SOME ENVIRONMENTS
Because working conditions may include ex-
posure to high noise levels that could lead to
hearing damage, the employer and the user
should make sure that necessary hearing
protection is provided and used by the oper-
ator and others in the work area.
3. DO NOT ALLOW CHILDREN NEAR THE
TOOL
Allow no bystanders, especially children,
near the tool during its operation.
4. DO NOT USE THE TOOL IN THE RAIN,
WHERE WATER IS SPLASHING, IN A
WET PLACE, OR IN A DAMP PLACE
Using the tool in these or similar conditions
will increase the risk of electric shock, dan-
gerous malfunction, and overheating.
5. INSPECT THE PARTS BEFORE MOUNT-
ING THE BATTERY PACK
• Examine the screws to make sure they are
securely tightened.
Incomplete tightening may result in an ac-
cident or breakage. If a screw is loose,
retighten it completely.
• Inspect parts for damage.
Parts will wear over periods of use. Look
also for missing and defective parts and for
parts of poor quality. If a part must be re-
placed or repaired, purchase the replace-
ment part at an authorized MAX Co., Ltd.
distributor.
Use only genuine authorized replacement
parts.
6. BE SURE TO SET THE MAIN SWITCH TO
OFF, TO LOCK THE TRIGGER, AND DE-
TACH THE BATTERY PACK WHEN
CHANGING THE BATTERY PACK, WHEN
REPLACING OR ADJUSTING THE TIE-
WIRE, WHEN ABNORMALITIES OCCUR,
AND WHEN THE EQUIPMENT IS NOT BE-
ING USED
Leaving the equipment switched on in these
situations may cause breakdowns or dam-
age.
7. KEEP FINGERS AND BODY PARTS
CLEAR OF THE FEEDER ARM AND CURL
GUIDE AT ALL TIMES
Failure to do so may result in serious injury.
Examine tightness
LOCK
OFF