Alpine SEC-8028 - Manual (Page 22)

English
22
Pre-Warn Chirp
Control
The SEC-8028 includes a dual stage
impact sensor which detects blows to the
body of the vehicle. If a light impact is
detected on the vehicle, the SEC-8028 will
issue a short warning chirp. If a heavy
impact is detected, the SEC-8028 will enter
an alarming state.
The SEC-8028 allows the pre-warn chirps
to be turned on and off.
Warning Mode
turns on and off both light flashes and siren
chirps.
Pre-Warn Chirp control will turn on
and off siren chirps while flashing the lights
if the system detects a light impact.
To Turn the Warning Mode
ON or OFF:
1. Make sure the system is disarmed and
not in Valet Mode.
2. Press the Valet/Disarm switch on and off
rapidly three times. (This procedure
must be completed in five seconds.)
3. The system will acknowledge the
command by chirping the siren and
flashing the lights twice (Pre-Warn Chirps
OFF), or three times (Pre-Warn Chirps
ON).
To Turn the Pre-Warn
Chirps ON or OFF:
1. Make sure the system is disarmed and
not in Valet Mode.
2. Press and release the TX/PANIC and
EXT1/VALET buttons simultaneously.
3. The system will acknowledge the
command by chirping the siren and
flashing the lights twice (Warning Mode
ON), or three times (Warning Mode
OFF).
TX/PANIC
+
EXT1/VALET
3x