Micromod MOD: 30ML Functions Data Base Reference User Manual
Page 38
MOD 30ML Functions
DISPLAY INTERFACE BLOCK
22
High Priority Process Alarms: Display Flash (FLSHHIPR)........................................... CWR
Use to specify if an unacknowledged hi priority process alarm (from PAD Block) will cause
the entire display to flash. The LED always flashes on an unacknowledged alarm.
NO
0
display flashing is disabled for an unacknowledged hi priority
process alarm.
YES
1
an unacknowledged hi priority process alarm will cause the entire
display to flash.
23
High Priority Process Alarms: Beep (BEEPHIPR)......................................................... CWR
Use to specify if an unacknowledged hi priority process alarm (from PAD Block) will cause
the beeper to beep.
NO
0
beeping is disabled for an unacknowledged hi priority process alarm.
YES
1
an unacknowledged hi priority process alarm will cause the beeper
to beep.
24
High Priority Process Alarms: Flash/Beep Rate (HFLSHRAT)..................................... CWR
Hi Priority process alarm flash rate for LED, display and beeper.
SLOW
0
flash rate as set by slow off and on counts.
FAST
1
flash rate as set by fast off and on counts.
25
Low Priority Process Alarms: Display Flash (FLSHLOPR) .......................................... CWR
Use to specify if an unacknowledged low priority process alarm (from PAD Block) will cause
the entire display to flash. The LED always flashes on an unacknowledged alarm.
NO
0
display flashing is disabled for an unacknowledged low priority
process alarm.
YES
1
an unacknowledged low priority process alarm will cause the entire
display to flash.
26
Low Priority Process Alarms: Beep (BEEPLOPR) ........................................................ CWR
Use to specify if an unacknowledged low priority process alarm (from PAD Block) will cause
the beeper to beep.
NO
0
beeping is disabled for an unacknowledged low priority process
alarm.
YES
1
an unacknowledged low priority process alarm will cause the beeper
to beep.
27
Low Priority Process Alarms: Flash/Beep Rate (LFLSHRAT) ...................................... CWR
Low Priority process alarm flash rate for LED, display and beeper.
SLOW
0
flash rate as set by slow off and on counts.
FAST
1
flash rate as set by fast off and on counts.
28
Port 3 Noise Counter (NOISECTR)................................................................................. – WR
Counts instances (from 0 to 65535) of noise error on internal communications port 3 (used by
faceplate and analog inputs).
29
Port 3 Buffer Full Counter (BFULLCTR) ......................................................................... – WR
Counts instances (from 0 to 65535) of buffer full error on internal communications port 3
(used by faceplate and analog inputs).
2-30