Perma Pure eCOOL 5000 Series - Manual (Page 14)

Section G: Boards 14
SW3 Function OFF ON
1 Heated Line Control OFF ON
2 Probe Control OFF ON
3 Peltiers 1 per channel 2 per channel
4 Channels 1 2
5 Peltier Power Share Full Power Power Sharing
6 ISO Channels Inactive Displayed
SW2 Function ON OFF
1 ICE VCC Enabled Disabled
2 JTAG ICE ResetN Enabled Disabled
3 Calibration Enabled Normal Operation
4 Dflash Res Enabled Normal Operation
5 Init Clr Enabled Normal Operation
Button Control
The buttons are used to control the calibration settings. Follow the bottom line on
the display to determine the functions in the different modes. The three
combinations that are available are left only, right only, or both. To select the center
option on the bottom line of the display, press both buttons together.
Calibration Menus
The calibration mode allows the board to be setup with min and span points as well
as all of the other configuration information applicable depending on the
configuration switch settings.
Ch1, Ch2, TC1, TC2
Min = 0
Span = 5 degrees C
Max = 8*Span Temp (360°C limit)
The calibration is performed by first calculating the expected settings for the
calibration resistors before entering the calibration operation to get a good starting
point. Then the 0 point is adjusted to the minimum point in the ADCC (memory
chip). The span temperature is then set and the span gain is adjusted to make the
span point 1/8 of the entire range for the temperature measurements.
ChX: MIN = xx  C
ChX: SPAN = xx  C