Perma Pure eCOOL 5000 Series - Manual (Page 25)

25
A
PPENDIX
: eCOOL
5000™
E Cool LAN Card Setup and Configuration
Setup:
1. Start a Hyperterminal session or similar terminal emulation software and configure it to
operate at 57600,8 data bits, No Parity, and 1 Stop Bit.
2. Disconnect power from the E Cool cooler card
3. Connect the E Cool LAN card that is to be configured with the following connectors:
a. JP15 - 10 pin connector to DB9 adapter to serial cable connected to PC.
b. JP16 - 10 pin ribbon cable to JP15 on the E Cool cooler board
c. P1 - Connected to Ethernet Cable
d. JP1 - Connected to +5V power and GND coming from the E Cool cooler board JP29.
4. Apply power to the E Cool cooler card
5. Press the reset button on the E Cool LAN card (SW1)
a. The Hyperterminal window should now have configuration information from the card.
b. The last line should show "ATMEL ok."
6. Add a shorting jumper to JP12 to allow EEPROM configuration
Configuration via terminal program:
1. Type bootinfo to get a list of the current settings for the card
2. Choose to Enable/Disable DHCP
If DHCP is enable, the DHCP server can be setup to assign a specific IP address to the
unique MAC address for the LAN card. The address is found printed on a label on the card.
The MAC address can also be obtained by holding down SW5 on the main control board an
monitoring the LCD display. By assigning the address in the DHCP server the card will get
the same address each time it is powered up.
a. To Enable DHCP enter dhcp enable
b. b.To Disable DHCP enter dhcp disable (factory default)
3. If DHCP is disabled: (factory default values shown)
a. Assign a static IP address

ip 192.168.45.145
b. Assign a DNSserver (if required; no value factory set)

dns xxx.xxx.xxx.xxx
c. Assign a default gateway

gw 192.168.45.100
d. Assign a subnet mask

subnetmask 255.255.255.0
4. Press the reset button on the E Cool LAN card (SW1)
Verify that the card gets either gets an IP address from the DHCP server or contains the
statically assigned IP address by monitoring the terminal program.
5. Remove the shorting jumper from JP12
6. Power down the E Cool controller card