Bosch BSG82212 schwarz Bodenstaubsauger Beutel ergomaxx professional 2200 W - Manual (Page 15)

10
en
Fold out picture pages.
Setting up
Figure
a) Insert the flexible hose adapter into the air intake open-
ing and allow it to engage.
b) To remove the flexible hose, press the two lugs together
and pull the tube out.
Figure
a) Align and connect the handle and the telescopic tube.
b) Push the handle straight into the telescopic tube until it
engages.
To release the connection, squeeze the collar sleeve and
pull the handle out.
Figure
Push the telescopic tube straight into the
connecting piece of the floor tool until it engages.
To release the connection, squeeze the locking collar
and pull the telescopic tube out.
Figure
Press the adjusting sleeve in the direction of the arrow
and adjust the telescopic tube to the length required.
Figure
Holding the power cord by the plug, pull out the required
length and plug the plug into the mains socket.
Figure
To switch your vacuum cleaner on and off, press the On/Off
button in the direction of the arrow.
6
5
4*
3*
2*
1
Vacuuming
You have bought an extremely powerful device. The high-
est suction setting is therefore only recommended for
heavily soiled, short-pile carpets and hard floors.
Figure
The required suction power can be selected by adjusting the
suction regulator.
Ⅲ Low
suction range:
For vacuuming delicate fabrics, e.g. curtains.
Ⅲ Moderate
suction range:
For daily vacuuming of lightly soiled floors.
Ⅲ High
suction range:
For vacuuming durable floor coverings, hard floors and
for heavily soiled surfaces.
Ⅲ Turbo range:
For vacuuming stubborn dirt and very heavily soiled sur-
faces.
Figure
Adjusting the floor tool:
a) For vacuuming rugs and carpets
=>
b) For vacuuming hard floors =>
Vacuuming with accessories
Figure
Pull the 4 in 1 tool in the direction of the arrow to remove it
from the tool holder.
a) Crevice nozzle
For vacuuming in crevices and corners.
For difficult to reach places, the 4 in 1 tool can be
extended to two different lengths by pulling out the
crevice nozzle.
Ⅲ For either length extension, pull the crevice nozzle out
until you hear it engage.
Ⅲ The crevice nozzle can be pushed back in again by
releasing the telescopic locking mechanism (pressing it
in the direction of the arrow).
b) Upholstery nozzle
For cleaning upholstered furniture,
curtains, etc.
c) Hard furnishings brush
For window frames, cabinets, profiles etc.
Ⅲ Fold the upholstery nozzle over in the direction of the
arrow.
Ⅲ To extend the brush ring, turn in the direction of the
arrow.
Before replacing the 4 in 1 tool in the tool holder,
retract the brush ring and fold the upholstery nozzle
back.
9
8
7