Andrew 9.3-Meter ESA - Manual (Page 19)

Step 4
Step 5
19
Installation Procedures
Figure 14
Refer to Figure 14. Apply supplied RTV to flange surfaces and loosely attach
200699/200021 elevation pivot assemblies to rear of enclosure drum assembly
•
Use 3/4 by 3.0 inch (75 mm) hardware
Slightly raising assembly and loosely attach 200016/200015 joint assemblies to bottom
portions of panning assembly.
•
Use 7/8 by 2-1/4 inch (57 mm) hardware
3/4 x 3” LG.
(75 mm)
200031A