Andrew 9.3-Meter ESA - Manual (Page 35)

35
Installation Procedures
Step 6
Subreflector
Assembly
Step 1
Refer to Figure 32. Loosely attach 300177 Subreflector Strut Supports to reflector as
shown ensuring brackets are installed on seam hole positions 15 and 16. Position
brackets clockwise as shown using brackets and hardware supplied as part of 300175
Subreflector Strut Kit.
Figure 32
Refer to Figure 33. Carefully remove subreflector subassembly and attached floating
ring from wooden crate. Remove six 3/4 in (19 mm) jam nuts and washers which attach
floating ring to subreflector assembly. Lift floating ring from adjustment studs.
Figure 33