Andrew 9.3-Meter ESA - Manual (Page 37)

37
Installation Procedures
Step 7
Step 8
Refer to Figure 35. Raise preassembled subreflector subassembly and strut assembly
and attach to subreflector supports as shown.
•
Use 1/2 x 2-1/2 in (64 mm) galvanized bolts, flat washers, lock washers and nuts.
Securely tighten mounting hardware. Mount tabs on strut assemblies to right side of
subreflector brackets to keep struts aligned with corresponding reflector segment sec-
tions.
Figure 35