Safe mode – PROLiNK PIC1005WN User Manual User Manual
Page 36
EN 33
3.17. Safe Mode
If by some abnormal operation, for example, powered off during the critical point of the upgrade procedure,
the IP Camera will enter into the safe mode. In this mode, you will see the following “Safe mode” page when
login into this IP Camera. Please do the upgrade operation immediately to recover the system. On this safe
mode, the IP Camera cannot display the video on the LiveView Software, but you can still find this IP Camera
on the “Auto search” list.
The steps to recover from “safe mode” are the followings:
1. Use LiveView to locate the IP Camera by clicking the “Auto Search” item on the LiveView Software.
2. Login into the web configuration page of the IP Camera.
3. Upgrade the firmware from the “Upgrade” page.
Figure 3-26: Safe mode information page