PROLiNK PPL1202N Quick Installation Guide - Manual (Page 28)

PROLiNK PPL1202N User Manual www.prolink2u.com
Version 1.00 (Jul’10) 28 English
The lower panel displays all the Powerline AP Ethernet devices, discovered on the current logical network (remote
devices). Displayed immediately above this panel is the number of remote devices found, the type of logical network
(Public or Private), and a message area that reports connectivity and scan status. The following information is displayed
for each of the devices discovered that appear in the lower panel:
Device Name column shows the default device name, which may be user re-defined. A user may change the name by
clicking on the name and editing in-place, or by using the rename button. An icon is optionally shown with the name.
A distinction in icons is made between low-speed and high-speed devices. By default, the icon is displayed with the
name.
MAC Address column shows the device's MAC address.
Password column shows the user-supplied device password (initially left blank). A user may enter the password by
using the Enter Password button. To set the Password of the device (required when creating a private network), first
select the device by clicking on its name in the lower panel and then click on the Enter Password button. A dialog box
will appear as shown in Figure 4 to type the password. The selected device name is shown above the field for entering
the password. Hit OK after entering the new password. A confirmation box will appear if the password was entered
correctly.
If a device is not found, the user will be notified and suggestions to resolve common problems will be presented.
Figure 4: Set Device Password