PSA LIF5800RL User Manual
Page 26
24
16. INSTALLER PLEASE NOTE
16.1 Before you connect the mains power, check wiring polarity.
16.2 If alarm ‘chirps’ intermittently, this sound is due to the “HUSH®” button
having been activated. Allow approximately 10 minutes for the alarm to
reset.
16.3 A new smoke alarm with built-in rechargeable battery may have low battery
voltage due to storage. It may require up to 8 hours for charging on mains
power to bring its battery to full capacity. The smoke alarm may chirp until
the battery is fully charged.
16.4 If the alarm ‘chirps’ again, press the Test button to check the battery condition.
16.5 If ‘chirps’ persists, replace smoke alarm and return to your supplier for re-
placement.
NOTE: NO USER REPLACEABLE PARTS INSIDE.
17. WARNING: INSULATION TEST
17.1 UNDER NO CIRCUMSTANCES MUST AN INSULATION RESIST-
ANCE TEST BE CARRIED OUT ON A CIRCUIT TO WHICH A
SMOKE ALARM IS FITTED.
17.2 THE TEST COULD CAUSE IRREPARABLE DAMAGE TO THE
INTERNAL CIRCUITRY OF THE SMOKE ALARM AND MAKE IT
INOPERATIVE.
17.3 THE WARRANTY WOULD BE VOID UNDER SUCH CIRCUM-
STANCES.
NOTE: WEEKLY TESTING IS RECOMMENDED!
1398-7208-03:_ 2012.6.13 4:24 PM Page 24