Alcatel Carrier Internetworking Solutions OmniStack 6300-24 - Manual (Page 347)

4-135
4
Example
The following example enables flow control on port 5.
Related Commands
negotiation (4-132)
capabilities (flowcontrol, symmetric) (4-133)
combo-forced-mode
This command forces the port type selected for combination ports 21 - 24. Use the
no form to restore the default mode.
Syntax
combo-forced-mode mode
no combo-forced-mode
• mode
- copper-forced - Always uses the built-in RJ-45 port.
- copper-preferred-auto - Uses the built-in RJ-45 port if both combination
types are functioning and the RJ-45 port has a valid link.
- sfp-forced - Always uses the SFP port (even if module not installed).
- sfp-preferred-auto - Uses SFP port if both combination types are
functioning and the SFP port has a valid link.
Default Setting
sfp-preferred-auto
Command Mode
Interface Configuration (Ethernet)
Example
This forces the switch to use the built-in RJ-45 port for the combination port 21.
shutdown
This command disables an interface. To restart a disabled interface, use the no
form.
Syntax
[no] shutdown
Console(config)#interface ethernet 1/5
Console(config-if)#flowcontrol
Console(config-if)#no negotiation
Console(config-if)#
Console(config)#interface ethernet 1/21
Console(config-if)#combo-forced-mode copper-forced
Console(config-if)#