Alcatel Carrier Internetworking Solutions OmniStack 6300-24 - Manual (Page 356)

Command Line Interface
4-144
4
amap enable
This command enables AMAP on the switch. Use the amap disable command to
disable the feature.
Syntax
amap {enable | disable}
• enable – Enables AMAP
• disable – Disables AMAP
Default Setting
Enabled
Command Mode
Global Configuration
Example
amap run
This command performs the same function as the amap enable/disable command.
Use the no form to disable AMAP on the switch.
Syntax
amap run
no amap run
Default Setting
Enabled
Command Mode
Global Configuration
Example
amap discovery timer
The time (in seconds) that switch ports in the Discovery state wait for a response to
a “Hello” packet from an adjacent switch.
Syntax
amap discovery timer seconds
• seconds – Discovery transmission timeout value in seconds
(Range: 1-65535 seconds)
Default Setting
30 seconds
Console(config)#amap enable
Console(config)
Console(config)#amap run
Console(config)#