Alcatel Carrier Internetworking Solutions OmniStack 6300-24 - Manual (Page 428)

Command Line Interface
4-216
4
Example
This example creates a policer that sets the maximum burst rate to 20 Kbytes, the
average rate to 1522 bps, and the response to drop any violating packets.
service-policy
This command applies a policy map defined by the policy-map command to a
particular interface. Use the no form to remove the policy map from this interface.
Syntax
[no] service-policy input policy-map-name
• input - Apply to the input traffic.
• policy-map-name - Name of the policy map for this interface.
(Range: 1-32 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
You can only assign one policy map to an interface.
Example
This example applies a service policy to an ingress interface.
show class-map
This command displays the QoS class maps which define matching criteria used for
classifying traffic.
Syntax
show class-map [class-map-name]
class-map-name - Name of the class map. (Range: 1-32 characters)
Default Setting
Displays all class maps.
Console(config)#policy-map rd_policy
Console(config-pmap)#class rd_class
Console(config-pmap-c)#set ip dscp 3
Console(config-pmap-c)#police 1000 1522 exceed-action drop
Console(config-pmap-c)#
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd_service
Console(config-if)#