Press & hold, Scene presets – ATON DLA6 User Manual
Page 27
© 2008 • All rights reserved. 25
DLA2/4/6 Speaker Level Audio Router
Scene Presets
Setting a Scene
A Scene Preset allows the volume level for each room to be saved and then recalled at any
time with the press of a button.
To set a Scene Preset:
Set the volume in each room to the desired level.
1.
Note: Any room whose LED is not lit (red or blue) will be considered OFF when setting
a Scene.
Press and hold the
2.
ALL ON/OFF Button for three seconds.
Press
& Hold
ROOM 1
ROOM 2
Once the Scene Preset has been saved, the Room LEDs for the rooms included in
3.
the Scene Preset will blink on and off four times and the system will return to the
levels prior to setting the Scene Preset.
Note: If a Room LED does NOT blink, it will not be activated when a Scene is selected.
Recalling a Scene Preset
The Scene Preset values for each room can be recalled in two ways:
Press the
1.
Scene Button on the IR Remote (or optional RF Remote).
Press the
2.
Vol + and Vol - simultaneously for one second on the front
of
the
unit.
Press
& Hold
ROOM 1
ROOM 2
Note: Scene Presets override Default Volume Levels.
Note: Room LEDs are BLUE for any Room with Volume greater than 0 and OFF for any
Room with Volume of 0.