AEG L 96485 FL - Manual (Page 29)

WARNING!
Make sure that the temperature is more than 0 °C before you use the appliance again.
The manufacturer is not responsible for damages caused by low temperatures.
TROUBLE SHOOTER AND SERVICE
The start of the appliance does not occur or it stops during operation.
Try to find a solution to the problem before you contact the service centre (refer to the
table).
With some problems, the acoustic signals operate and the display shows an alarm mes-
sage.
WARNING!
Deactivate the appliance before you do the checks.
Problem Possible cause Possible solution
The display tells to
check the tap: the
appliance does not
fill with water.
The water tap is closed. Open the water tap.
The water inlet hose is dam-
aged.
Make sure that the water inlet hose has
no damages.
The filters in the water inlet
hose is blocked .
Clean the filters. Refer to 'Care and
cleaning'.
The connection of the water
inlet hose is not correct.
Make sure that the connection is cor-
rect.
The water pressure is too low. Contact your local water authority.
The water tap is blocked or is
furred with limescale.
Clean the water tap.
The display tells to
check the drain filter:
the appliance does
not drain the water.
The water drain hose is dam-
aged.
Make sure that the water drain hose has
no damages.
The filter of the drain pump is
blocked.
Clean the filter of the drain pump. Refer
to 'Care and cleaning'.
The connection of the water
drain hose is not correct.
Make sure that the connection is cor-
rect.
The display tells to
check the door.
The appliance door is open or
not closed correctly.
Close the door correctly.
The display tells there
is a water alert.
The anti-flood device is activa-
ted.
• Disconnect the appliance.
• Close the water tap.
• Contact the service centre.
Trouble shooter and service 29