AEG L 96485 FL - Manual (Page 36)

CAUTION!
Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the
level.
The inlet hose
35 O 35 O 35 O
45 O 45 O 45 O
• Connect the hose to the appliance. Turn
the inlet hose only left or right. Loose the
ring nut to set it in the correct position.
• Connect the water inlet hose to the cold
water tap with 3/4 thread.
CAUTION!
Make sure that there are no leaks from the
couplings.
Do not use an extension hose if the inlet hose is too short. Contact the service centre for
the replacement of the inlet hose.
Water-stop device
A
The inlet hose has a water stop device. This
device prevents water leaks in the hose be-
cause of its natural ageing. The red sector
in the window «A» shows this fault .
If this occur, close the water tap and con-
tact the service centre to replace the hose.
36 Installation