AEG L 96485 FL - Manual (Page 37)

Water drainage
There are different procedures to connect the drain hose:
With the plastic hose guide.
• On the edge of a sink.
• Make sure that the plastic guide cannot
move when the appliance drains. Attach
the guide to the water tap or the wall.
• To a stand pipe with vent-hole.
Refer to the illustration. Directly into a
drain pipe at a height of not less than 60
cm and not more than 100 cm. The end
of the drain hose must always be venti-
lated , i.e. the inner diameter of the
drainpipe must be larger than the exter-
nal diameter of the drain hose.
Without the plastic hose guide.
• To a sink spigot.
Refer to the illustration. Put the drain
hose in the spigot and tighten it with a
clip. Make sure that the drain hose
makes a loop to prevent that remaining
particles go in the appliance from the
sink.
Installation 37