ATON Source Input Wall PlateWallplate DHSIP - Manual (Page 10)

8 ©2008 • All rights reserved.
DHSIP Source Input Wall Plate
Installation
The DHSIP is designed to mount in a standard single-
gang rough-in box (J Box). Mount the unit in close
proximity to the location of the source that will be
connected to it.
Note: Do not mount the DHSIP in the same
rough-in box as high voltage devices such as
electrical outlets or switches.
After running Cat-5 and terminating the ends, route
the wire into the back of the rough-in box, connect it
to the RJ-45 connector on the rear of the DHSIP, and
mount using the 2 provided screws. See Figure 2.2.
Screw
Screw
DHSIP
Rough-In
Box
Cat-5
Stud
Screw
Screw
Figure 2.2: Installing the DHSIP