ATON Source Input Wall PlateWallplate DHSIP - Manual (Page 3)

© 2008 • All rights reserved. 1
DHSIP Source Input Wall Plate
Safety Information
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if not in-stalled
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifi cations not expressly approved by ATON
could void the user’s authority to operate the equipment
Clean only with a dry soft cloth.
It is important to properly care for your DHSIP. Follow these guidelines
to ensure your device is preserved and protected.
Do not expose the DHSIP to rain, liquids or moisture for an
extended period of time.
Do not expose the DHSIP to temperature extremes.
Operating Temperatures & Environments
Operating Temperature: 32-104°F (0-40° C)
Humidity: 0-90%
•
•
•
•
•
•
•
•