Teledyne TED-200 - Medical application oxygen monitor User Manual
Page 35
Appendices
A-9
Teledyne Analytical Instruments
NOTE: The oxygen sensors are sealed, and under normal circumstances, the
contents of the sensors do not present a health hazard. The following
information is given as a guide in the event that a cell leaks.
Protective clothing:
Rubber gloves, chemical splash goggles.
Clean-up procedures:
Wipe down the area several times with a wet paper towel.
Use a fresh towel each time.
Protective measures
during cell replacement:Before opening the bag containing the sensor cell, check the
sensor cell for leakage. If the sensor cell leaks, do not open
the bag. If there is liquid around the cell while in the instru-
ment, put on gloves and eye protection before removing the
cell.
Disposal:
Should be in accordance with all applicable state, local and
federal regulations.
NOTE: The above information is derived from the MSDS provided by the manu-
facturer. The information is believed to be correct but does not purport
to be all inclusive and shall be used only as a guide. Teledyne Elec-
tronic Technologies shall not be held liable for any damage resulting
from handling or from contact with the above product.
Section VI – Handling Information
Eye Contact:
Flush eyes with water for at least 15 minutes and get immediate
medical attention.
Skin Contact:
Wash affected area with plenty of water and remove contaminated
clothing. If burning persists, seek medical attention.
Ingestion:
Give plenty of cold water. Do not induce vomiting. Seek medical
attention. Do not administer liquids to an unconscious person.
Inhalation:
Liquid inhalation is unlikely.
Section V – Emergency and First Aid Procedures